#1
|
|||
|
|||
ModelManager+
hi folks,
i've got a problem installing mm+ on my server. i installed the way the manual says, but after installing, nothing happens. in earlier versions a dialog appeared, which asked me to enter the paths to office, drafting and so on. but since 13.20b, nothing happens. this is what I did: -executed the modelmanagerplus.exe -started mmbuild.bat -executed new generated ModelManagerSetup.exe from distribution-server ..and then was silence mmbuild.bat executed successfully, no errors; new ModelManagerSetup.exe has been generated. have you already installed mm+ and faced the same problems or is there any hint???!!??? basti P.S.:i used new versions 14 to test!!! Last edited by nephilim; 02-22-2006 at 01:37 AM. |
#2
|
|||
|
|||
Re: ModelManager+
Hi,
Did you install additional - non CoCreate - applications since last success? Check about CLASSPATH environment variable; MM+ requires this variable to be empty for now. Alternatively you can use a batch script ModelManagerSetup.bat including: set CLASSPATH= .\ModelManagerSetup.exe I experienced a similar situation even on 13.20A and now this is the way I currently use on my WS. Best Regards Louis |
#3
|
|||
|
|||
Re: ModelManager+
...problem solved...a little environment-variable has to be set to show up the missing dialog when installing. rtfm@me *grml*
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | Search this Thread |
Display Modes | Rate This Thread |
|
|