#1
|
|||
|
|||
Mirror Shared parts (Done in OSDM 2007)
The ability to share mirrored parts would be a powerful tool, I believe.
Thanks |
#2
|
|||
|
|||
I think that mirror shared part could be useful in sheet metal.
|
#3
|
||||
|
||||
http://www.cocreateusers.org/forum/showthread.php?threadid=4306
http://www.cocreateusers.org/forum/showthread.php?threadid=4170 Last edited by Michael Kahle; 10-29-2003 at 10:13 AM. |
#4
|
||||
|
||||
Re: Mirror Shared parts
Is this still pending?
Or it has solution in the late release? bye Stefano
__________________
AGC Memory: 12K fixed (ROM), 1K eraseable (RAM) Clock: 1.024 MHz Computing: 11 instructions, 16 bit word |
#5
|
||||
|
||||
Re: Mirror Shared parts
For the 2007 release of Modeling, there is a new option under the Mirror command to create "mirrored shared parts". FYI - When using the option, a geometry check is performed automatically to ensure symmetrical conditions.
__________________
David@CoCreate |
#6
|
|||
|
|||
Re: Mirror Shared parts (Done in OSDM 2007)
Hi,
But is it possible to keep a link between both parts (the original and the symetrical one) in order that modifications will be made on both (even if they are really symetrical and not identical ) ? Thanks for your answers. |
#7
|
||||
|
||||
Re: Mirror Shared parts (Done in OSDM 2007)
Looks like you found something for a new enhancement thread ;-)
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|