#1
|
||||
|
||||
Automatic Density in SheetAdvisor
One of our "new" OSD users was very surprised to find out that a part made in SheetAdvisor didn't have a density.
After all, the system "knows" that the part is made from steel, aluminium, whatever (sounds logic, doesn't it?). So, my enhancement request for SheetAdvisor: an extra "density" variable in the toolshop (to be added to each material in the "materials" table) that, if set, would set the density of a new sheet part automatically. Regards, Jaap Kramer |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | Search this Thread |
Display Modes | Rate This Thread |
|
|