#1
|
||||
|
||||
OSDM 11.60 with Netmeeing 3.01
Beside using OSD Collaboration, I sometimes also use Windows(2000) Netmeeting(3.01) via intranet to carry out quick support for OSD Modeling and Drafting. I just realized that the interface (menu, toolbars and etc) of OSDM being updated accordingly in Netmeeting guests' shared screen except the viewport in OSDM. Viewport will not be refreshed in guests' screen even though they can take over control and draw/manipulate the model. Hence, guests can't see model from owner's viewport on their screen.
The weird thing is that OSD Drafting works just fine with Netmeeting. Solution is much appreciated. |
#2
|
||||
|
||||
To use SolidDesigner or Modeling with NetMeeting, you need to disable the 3D Hardware graphics. You can do this by setting an environment varible as follows before starting Modeling.
SDPIXELFORMAT=SOFTWARE For older versions of SolidDesigner, you may need to use PIXEL_FORMAT=SOFTWARE
__________________
John Scheffel |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | Search this Thread |
Display Modes | Rate This Thread |
|
|