#1
|
|||
|
|||
Newbie needs assistance.
I just started using CoCreate, and it's a little different than what I'm used to. My problem is that I started drawing a part, saved it as a .mi file, and now when I've reopened it the entire drawing acts like a single block, including my BOM. I can't modify single elements of the drawing. I looked for something like "explode", and found smash_poly, but that didn't help. Is this caused by saving as a .mi file? Any ideas? Thanks.
|
#2
|
|||
|
|||
Re: Newbie needs assistance.
I just figured it out. It has something to do with my company's pre-made frames. I'll check with them.
|
#3
|
||||
|
||||
Re: Newbie needs assistance.
You're probably looking for edit part. Depending on the level of complexity of what you're drawing, you may just want to edit TOP (TOP being the name for the highest level part). Be sure not to do work inside the frame (don't edit part on the frame), as they usually have special scaling.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|