#1
|
||||
|
||||
Improvement of symmetrial line
In lots of cases i have problems placing a symmetrical line. Obvious cases.
See example. I tried to add a sym line on the plate in the middle. By no means this can be misunderstood : it is a plate made from a sketch on a workplane.......
__________________
I use Cocreate Modeling 2008 (x64 edition) and Cocreate Drafting 2008 |
#2
|
||||
|
||||
Re: Improvement of symmetrial line
Do you mean symmetry lines in Annotation?
__________________
CoCreate Modeling FAQ: http://www.clausbrod.de/CoCreateModeling/ |
#3
|
||||
|
||||
Re: Improvement of symmetrial line
Yes. The plate is parallel 100% but still in Annotation it refuses to place a symm line.
__________________
I use Cocreate Modeling 2008 (x64 edition) and Cocreate Drafting 2008 |
#4
|
||||
|
||||
Re: Improvement of symmetrial line
Is this really an enhancement request, or just a bug report? Also, did you already discuss the issue in the Annotation to see if there are already solutions for the problem?
__________________
CoCreate Modeling FAQ: http://www.clausbrod.de/CoCreateModeling/ |
#5
|
||||
|
||||
Re: Improvement of symmetrial line
Because it is still an issue and still nothing done about it : It is an enhancement request since it is not even possible to put a symmetry line for simple situations! See added image.
I tried to place a sym line (Aux geo => sym line) on different symmectrical entities but nooooooo he will not draw that sym line. I dont know if it is a bug. But i do know i want this to be possible. And not by using a workaround. Just by doing what it has to do.
__________________
I use Cocreate Modeling 2008 (x64 edition) and Cocreate Drafting 2008 |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|