|
|
|||||||
|
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
|
#1
04-18-2002, 05:21 AM
|
|||
|
|||
|
horiz segment disappears from dim. leader lines
Since upgrading to v11.00, the horizontal part of the leader lines on my diameter and radius dimensions disappear when I reload a drawing. Does anyone else have this problem? Any ideas?
|
|
#2
04-19-2002, 04:36 AM
|
|||
|
|||
|
re: horiz segment disappears from dim. leader line
Yes this problem is a known bug in ME10 v11.0. It shows up consistantly on SolidDesigner associated radius and diameter dimensions in ME10. There are also some serious bugs in the dimensioning section as well. I was told to hold off on rev 11.0 and wait for 11.5 in the May time frame.
|
|
#3
10-15-2002, 02:27 AM
|
|||
|
|||
|
re: horiz segment disappears from dim. leader line
Try this; in your startup, or on your ME10 command line, type in RTL_OLD_BEHAVIOUR ON.
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
