#16
|
|||
|
|||
Re: change color
ah strange.
i rewrite the macro DEFINE linea_bianca LOCAL Pnt1 LOCAL Pnt2 LOOP READ PNT 'indicare il primo punto della linea o inserire un'opzione' Pnt1 READ PNT 'indicare il secondo punto della linea o inserire un'opzione'Pnt2 LINE WHITE Pnt1 Pnt2 END END_LOOP END_DEFINE but don't work! |
#17
|
|||
|
|||
Re: change color
1-ok i use your last macro and it work but there is another problem! when ask me for first point i don't see the node where i will place first point, same for second.
if i use two point assistance? i will have the projection help? 2-second problem is about change color when change color i use only cursor point and i can not use rectangle selection |
#18
|
||||
|
||||
Re: change color
you write: ...................................Problem v
'indicare il primo punto della linea o inserire un'opzione' this must be: 'indicare il primo punto della linea o inserire un opzione' or "indicare il primo punto della linea o inserire un 'opzione' " Typewriter double quotes " Pay attention. In this macro you can't give options, only points. Try alternative this READ PNT 'indicare il secondo punto della linea' RUBBER_LINE Pnt1 Pnt2 |
#19
|
||||
|
||||
Re: change color
Quote:
You can combine your most used commands easy in your own toolbar It is not possible to use the features of Assistance in macros. Quote:
|
#20
|
|||
|
|||
Re: change color
thanks very very much!
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|