|
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
#1
|
||||
|
||||
Arrow style can be applied Circular and Linear dimension indivisually?
Hi.
I wanted to have circular diameter dimension with only one arrow. So I set the default setting for dimension's secondary arrow setting 'none'. Then it applied to the linear dimension too. Can this default applied for linear and circular each indivisually? P.S. I even do not want the radial line left over to the diameter dimension, either. But it seems I cannot eliminate the line.
__________________
Toshi |
#2
|
||||
|
||||
Re: Arrow style can be applied Circular and Linear dimension indivisually?
You can make use of the so called on the fly styles and settings.
In settings browser on the DIMENSION node create two different new styles a) 'Circ Dim' with the wanted arrow styles b) 'Lin Dim' with the wanted arrow styles c) in the MISC section of settings browser there is one which defines which style has to be used when a dimension dialog is opened. Set this one to individual. Now open Single Dim and select the style 'Lin Dim'.. create a dim. Exit, open again and the style is still there. Now open Diameter Dim and select the style 'Circ Dim'.. create a dim. Exit, open again and the style is still there. For every Dim Type the last Dim style used is recognized now. Even when you terminate OSD AM and start a new session tomorrow, or next week. BUT once you selected "MyFunnyStyle" in one of the dimension create action this one will be the default next time you open the same dimension create action.
__________________
|
#3
|
||||
|
||||
Re: Arrow style can be applied Circular and Linear dimension indivisually?
Thank you I followed your instruction, Wolfgang, and I seem to have understood about this feature.
Somehow, I could eliminate the center line for diameter dimension too. Thank you for your answer. I appreciate you. Best Regards.
__________________
Toshi |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|