CoCreate User Forum  

Go Back   CoCreate User Forum > Old NewsGroup Archive > Archive Forums > Advisors

Thread Tools Search this Thread Rate Thread Display Modes
Old 11-18-1998, 07:01 AM
Peter Kunz
Posts: n/a
Fold Macro

Does anyone know of or have access to a macro, enhancement or third party program to fold 2D legacy flat patterns into a solid model part?
Old 11-24-1998, 05:47 PM
Mario Fischer
Posts: n/a
re: Fold Macro

Hello Peter, The version 7.0 of SolidDesigner and SheetAdvisor will contain a new functionality that allows to unfold and fold sheet metal in 3D. When you have a 2D profile you need to extrude it and imprint the bend areas into the extruded part. Using the new functionality you can then fold each of these bend areas.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are Off
[IMG] code is On
HTML code is On

Forum Jump

All times are GMT -8. The time now is 07:00 AM.

Hosted by SureServer    Forums   Modeling FAQ   Macro Site   Vendor/Contractors   Software Resellers   CoCreate   Gallery   Home   Board Members   Regional User Groups  By-Laws  

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.