Re: lost commands from 19 to 20 direct modeling
Hi,
if I look at it this way, I have these commands too.
It saves one click compared to the yellow selection arrow.
The notation is by me
Instead of :part by me 'SELECT':PART
but this only makes sense if you want to select e.g. a cylinder.
Thus selection of the part by click on a surface.
Instead of :assembly by me 'SELECT':ASSEMBLY
That makes sense. Very convenient.
But selecting a 3D surface is what Modeling does anyway.
Can you explain why this is so good?
I hope I understood you correctly. ;-)
Have a nice Easteregg hunt.
Buenos Aires
Last edited by Friedly; 04-08-2023 at 08:45 PM.
|