[BMaverick]

You may need to put in an enhancement request directly to CoCreate. The forums here are mainly user support by users of Cocreate, however there are a few CoCreate support employes that check these forums from time-to-time. So, your request may not go any higher than this thread.

As a user of CoCreate, I totally understand your request of being able to show vairous configurations up the assembly tree to the master assembly. I have several stamped parts that get folded and clinched together at various steps in an assembly. Some univeral brackets we have get tabs folded while used in other families the tabs are for locating and clinching.

We are doing all of this without MM.

I cheat by importing SAT copy files in and out of the various assemblies. There is no Master Model approach to solving this that I'm aware of.