|
Re: Updating views : possibility for interrupting
I quit using the Autosave feature several version ago because I was experiencing the same issue.
If I had autosave on, and I updated a large view or drawing, there were times that everything just froze up and I could not recover.
After turning autosave off, the problem went away. I have not tried autosave since.
Tom
__________________
Tom Kirkman
Creo Elements/Direct 20.1
Dell Precision 3581
https://www.o-i.com
Last edited by tom kirkman; 06-25-2009 at 05:30 AM.
|