Re: Create 3D Sketch
I've included some screenshots of what I'm trying to accomplish in Solidworks 2007. Basically I've set up at least one plane for every tube as I have explained already, and then defined an axis that runs down the middle of each tube. From there, I am making a 3D sketch to retrace the geometry. This is necessary so that I have a 3D line representation of the frame for my Finite Element Analysis.
I would like to learn how to do this exact same thing in CoCreate Ver 16.0. I've managed to create sketches using the 2D Co-Pilot however only on one single working plane. What I would like to have is one single 3D sketch of the entire frame.
Any help is much appreciated.
|