Wrong view by face of a part
If I see a part in a wrong way like this, I can only move the face in the right way or another way is possible?
Thanks for the help http://oi67.tinypic.com/6sxj5g.jpg |
Re: Wrong view by face of a part
Is the part in the picture already viewed by face?
|
Re: Wrong view by face of a part
Yes, I've used the command view by face and I've clicked on the face I see
|
Re: Wrong view by face of a part
5 Attachment(s)
This is going to be a long explanation. First, what I found is that view by face goes back to how the face was created. In the first image below, the part was drawn at 45° off of vertical in the workplane.
The view by face shows the part at 45°. I selected the face, and moved the face by rotation 45°. Then view by face shows the part in the vertical orientation. This is a lot of work that really does not buy much, unless you truly need the face shown in that orientation. Attachment 1988 Attachment 1989 Attachment 1990 Attachment 1991 Attachment 1992 |
Re: Wrong view by face of a part
Nice!
I'll trye ;) |
Re: Wrong view by face of a part
Thanks for the help, I tought there was a command like "new"coordinate system" that sorts the face orentation out, without move the face.
|
Re: Wrong view by face of a part
Kaji
That could be, let me know if you find anything. Tom |
Re: Wrong view by face of a part
Quote:
Thaks for the help, but I don't want you to spend time |
All times are GMT -8. The time now is 01:07 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.