Change reference point of a Part
Hi all :D
There is a way se view reference point of a part / group? And change it? So i can change origin of a part / group I found command only for WorkPlane Thanks :cool: |
Re: Change reference point of a Part
Shaba
Are you wanting to move the view sets of a part to change the orientation in the drawing? Regards Tom |
Re: Change reference point of a Part
No, sorry for my last poor explanation
I have 0,0,0 of my 3d system I insert an existing 3d component and i need that it is put into 0,0,0 but this don't happen! It is near sometimes, far other times So i need a command to set 0,0,0 origin of this component. See image https://s24.postimg.org/kf4qu38q9/Image1.png I hope i'm a bit clear now.. |
All times are GMT -8. The time now is 05:36 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.