PDA

View Full Version : Really stupid question


papa_lazerous
02-07-2009, 02:11 PM
Hi all 1st post (yup I found the forum whilst googling in vain for a solution)

Getting to grips with CoCreate but there is one thing I have no idea how to do and its killing me as its got to be simple.

I am working on something right now where I want to have more than one part. I see P1 to the left in the structure browser, how on earth do I creat for example P2 or P3 I have spent a few days browsing help files and going through tutorials. I must be missing something quite simple

I would appreciate a clue, or even an answer. Might just save me loosing my sanity

John

wathavy
02-08-2009, 12:39 AM
Hi, John.
Welcome to the nightmare of the Modeling User Interface.
This is awful isn't it? :D

All you need to do is to ' Create a part ', instead it says 'New Part' as attached.

I could not figure out for long time too, until I saw a webinar on PE1 and PE2.

I wonder if those are available yet on their webinar site.... :confused:

wathavy
02-08-2009, 12:51 AM
I googled and I found two of them.
http://www.cocreate.com/learn/2007_Getting_Started_PE1.aspx
http://www.cocreate.com/learn/2007_Getting_Started_PE2.aspx
These are quite good for the beginners (like us).:)

papa_lazerous
02-08-2009, 10:15 AM
How on earth did I not see that, many thanks