cvedrick
06-24-2008, 09:56 AM
Simple Question, but frustrating.
I have a model ahtta has three seperate entities in it.
One of the entities is a rounded tool that should go into a slot in the other entities. all three are on the same work plane.
However the tool is 90 deg. off of where it needs to be.
If I am looking at the workplane view, I see it end on and I need to see it full length.
Is there some type of "rotate" or "spin" sommand that will do this for me, or do I need ro re-create it on a perpindicular workplane?
I have a model ahtta has three seperate entities in it.
One of the entities is a rounded tool that should go into a slot in the other entities. all three are on the same work plane.
However the tool is 90 deg. off of where it needs to be.
If I am looking at the workplane view, I see it end on and I need to see it full length.
Is there some type of "rotate" or "spin" sommand that will do this for me, or do I need ro re-create it on a perpindicular workplane?