Is PE upgraded for Vista? Any news?

[wathavy]

Hi.
I have only XP or W2K yet, so I should not worry about.
But is PE going to be released for Vista?

[Mike Swartz]

I have tested pre-beta Modeling PE on Vista, but have no information on the release.
There is a signup on the Modeling PE forum. You should go there.

http://apps.cocreate.com/OneSpaceModelingPE/Secure/Forum/category-view.asp

[clausb]

Hi all,

check out http://www.cocreate.com/free - CoCreate Modeling PE 2.0 is now available from that site, and the new version also installs and runs on Vista.

The new version has numerous other improvements, so make sure to check out the "What's New" document at http://www.cocreate.com/assets/datasheets/Modeling_PE2_whats_new_EN.pdf .

Claus

[highway45]

Thanks for the Info !
Unfortunately it is not possible to save a part made with PE 2.0 into Version PE 1.0 :(
But I am very happy about meeting the UNDO function in Annotation finally !! :)
BTW: the display of transparent parts in 3D looks much prettier than before.

-------------
Matthias