gormie
10-11-2007, 01:35 AM
As the title says, The ability to add a trace line along the centre of a part to it's origin when exploded within an isometric view. Although the dynamic modelling has no history that should prevent an automatic creation of such a line the use of configurations has a history of start position and end position. Admittedly if the trace lines were for a part moved in two or three dimensions then it would probably fall over since the transfer of positional data to an exploded position shows the shortest route, but a single one dimensional movement should be easy to create.
Both requests can be achieved manually and I suppose I'll have to start learning lisp to create such functionality until these features are added
Edited by Adminstrator. This was orginally part of a thread containing two distinct ehancement requests. It was divided into two threads to be consistent with how this forum is used.
Both requests can be achieved manually and I suppose I'll have to start learning lisp to create such functionality until these features are added
Edited by Adminstrator. This was orginally part of a thread containing two distinct ehancement requests. It was divided into two threads to be consistent with how this forum is used.