View Full Version : Machining
luigimilano
12-19-2006, 05:23 AM
If I make a Threaded Hole (through hole) in a part when the opposite face is conical the operation corrupt the part. If the opposite face is a planar face it's all right.
Is this a bug?
Thanks in Advance
Best Regards
daham
10-29-2007, 12:27 PM
From what you describe it sounds like a defect. However, it appears to have been fixed. What version of Modeling are you currently using?
luigimilano
10-29-2007, 11:53 PM
Dear Daham
Now I'm using 15.50 with this version work fine.
Thank-you very much
Best Regards
Luigi Milano
vBulletin® v3.8.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.