last_option
11-22-2006, 01:20 PM
Hello,
Here is my daily rant. It seems to be a good stress relief to post my feelings on this forum. I am not sure if anyone reads them but it is very therapeutical.:p
At any rate, here are my thoughts, as limited as they may be.
When I am drawing a profile on a workplane once it is a closed profile an arrow similar to the one used in the mill function should show up at a corner of the profile. Now this doesn't mean that you can't add more 2d, it's just feedback that a closed profile has been created. When you add more 2d obviously the profile would be open again and the arrow would disappear, until and new closed profile was created. This is nice because it will let you know the profile is closed before pressing a function button.
On to the arrow, this is no ordinary arrow it is two different colors the tip would be green and the back would be red. By clicking on the green you could pull it out just like the milling operation creating a transparent box. Just like milling function you could enter a number or select faces, point, etc.. to define the box. If you select the red part of the arrow you can change the direction to a user defined, global, or local direction.
Now the meat, once the box is created you can right mouse click and bam! select milling, my new stamp idea, my new section idea, old stamp punch, old section punch, punch, and anything else you want to do with a transparent box.
See more info on my new stamp idea and my new section idea in previous post.
Tomorrow is thanksgiving so I will have to let you down.
Thanks,
Here is my daily rant. It seems to be a good stress relief to post my feelings on this forum. I am not sure if anyone reads them but it is very therapeutical.:p
At any rate, here are my thoughts, as limited as they may be.
When I am drawing a profile on a workplane once it is a closed profile an arrow similar to the one used in the mill function should show up at a corner of the profile. Now this doesn't mean that you can't add more 2d, it's just feedback that a closed profile has been created. When you add more 2d obviously the profile would be open again and the arrow would disappear, until and new closed profile was created. This is nice because it will let you know the profile is closed before pressing a function button.
On to the arrow, this is no ordinary arrow it is two different colors the tip would be green and the back would be red. By clicking on the green you could pull it out just like the milling operation creating a transparent box. Just like milling function you could enter a number or select faces, point, etc.. to define the box. If you select the red part of the arrow you can change the direction to a user defined, global, or local direction.
Now the meat, once the box is created you can right mouse click and bam! select milling, my new stamp idea, my new section idea, old stamp punch, old section punch, punch, and anything else you want to do with a transparent box.
See more info on my new stamp idea and my new section idea in previous post.
Tomorrow is thanksgiving so I will have to let you down.
Thanks,