View Full Version : ModelManager+

02-22-2006, 01:26 AM
hi folks,

i've got a problem installing mm+ on my server. i installed the way the manual says, but after installing, nothing happens. in earlier versions a dialog appeared, which asked me to enter the paths to office, drafting and so on. but since 13.20b, nothing happens. this is what I did:
-executed the modelmanagerplus.exe
-started mmbuild.bat
-executed new generated ModelManagerSetup.exe from distribution-server
..and then was silence :mad:
mmbuild.bat executed successfully, no errors; new ModelManagerSetup.exe has been generated.
have you already installed mm+ and faced the same problems or is there any hint???!!???:confused:


P.S.:i used new versions 14 to test!!!

02-27-2006, 06:31 AM

Did you install additional - non CoCreate - applications since last success?
Check about CLASSPATH environment variable; MM+ requires this variable to be empty for now. Alternatively you can use a batch script ModelManagerSetup.bat including:
I experienced a similar situation even on 13.20A and now this is the way I currently use on my WS.
Best Regards

03-22-2006, 07:29 AM
...problem solved...a little environment-variable has to be set to show up the missing dialog when installing. rtfm@me *grml*:(