how to apply "by solid" of sheetmetal

[stevenyuan]

in sheet metal,
that have one command.
that is "by Solid"
in "by Solid",there have one option.it is "Neight Edge",
do you know ?
"Neight Edge" have some actual function?
if you know,
please tell me.
i have test it long long ago!
but i don't know that how to do it.
thanks very much.

[stevenyuan]

if everybody understand it.
please tell me.
thanks very much.
this question has worry mea month of Sundays

[stevenyuan]

i'm very pang for this question.
:confused:
who can help me?
thanks very very much!
i wait...........................

[joachim]

"Neighb Edge" stands for "Neighbour Edge" and could be used in
concave edges (with option "inside")
or on
convex edges (with option "outside")
when a further sheet part which meets at this edge is not simultaniously defined with the actual new sheet. If set, the option will shorten the actual lip
at the defined edge, to avoid an overlap with the neighbour sheet metal part which might have been defined earlier or will be defined later.

See attached picture

[stevenyuan]

Joachim,
thanks very much
now i have understanded,
thanks very much