PDA

View Full Version : Bom flag for layered assy.


bdining
08-09-2005, 08:40 AM
I have an assembly with layered parts. I wish to add BOM flags along the front edge that would ID the 3 parts that are stacked together.

I have tryed using the table method but when I go to select the front edge an error pops up saying
"Picked geometry does not correspond to selected BOM component"
The part turns green once I select it from the table, but it will not allow me to pick the edge for arrow placement.
Is there a method of selecting layered parts without making a cutaway?

Attachment shows what I am looking for.

Thank You
Bill