Trailing Contruction Lines

[TroyS]

I am trying to run Designer Modeling on a HP notebook. 2.8Mhz Celeron Processor, ATI Radeon 9000 Video Card. When I am putting in Contruction or Geometry lines, I can see them trailing behind my cursor. I tried installing a new 2.8Mhz P4 today and had the same result. I also upgraded my memory from 512 to 760. Any suggestions, I have have been emailing Cocreate and they said this should work.

[Thom Ivancso]

Hello Troy,

Do you have mouse cursor shadow turned off, if the mouse cursor shadow is turned on it can sometimes cause trailing issues on workplanes.

You can turn this off by going into the mouse properties in the control panel on Windows.


hth
Cheers
Thom

[clausb]

Check out the discussion at http://cocreateusers.org/forum/showthread.php?t=5053 - sounds like the same problem. See also http://www.clausbrod.de/Osdm/OsdmFaqGraphics#radeon_zbuffer .

Claus

[TroyS]

Thank you so very much, this worked perfectly. I cannot say thank you enoough, I thought I was just going to have to buy a new laptop. Your help is greatly appreciated.