Regarding commands

[vemanamar]

Hi cocreaters :) ,

will any one give me the command syntax for measuring maximal 3d point in OSD. I refered in the "Command Reference" section of the help documentattion.
:rolleyes: But invain, i couldn't find.

please send

with regards,
Amar

[dorothea]

The general way to get the syntax of commands is to use the recorder. Type into command line:
(load "recorder")
In the toolbox there appears a button "Recorder". With this tool you can record any command sequence. Just start the measure command after the recording started. Give all necessary parameters (by clicking the buttons in the ui). Close the recorder and check what's written in the file.

Dorothea