PDA

View Full Version : Bom and Scan


JOSEMARI
12-09-2004, 11:04 PM
We have:

WorkManager Desktop 11.65 Design Management 05.22.2003
CoCreate One Space Designer Modeling 2002+ 11.65A 12-Aug_2003

The SACAN and open BOOM are active in the menu but don't work.
See file.
When selecting an assembly for scanning the following error appears:

The macro Awmc_bom_il_scan_sd is not defined.

Please indicate if there is an extra module or the basic should work.
Thank you in advance

alexniccoli
12-15-2004, 11:09 PM
Hi jose
have you installed cad integrations during workmanager client installations?
Try to reinstall workmanager client checking all three integrations.

JOSEMARI
12-20-2004, 11:31 PM
Thank you very much for your answer.
The software was reinstalled by our soft supplier. They had a lot of trouble the last time they did it. I do not want to do it myself and have a conflict with them. We have a manteinance contract.
I would like to know if the BOM and SCAN is part of an extra module, as our supplier says, or it is just that something is not properly installed, and we can push them to repare it.
Thak you very much in advance.
Juan

alexniccoli
12-21-2004, 01:36 AM
Thank you very much for your answer.
The software was reinstalled by our soft supplier. They had a lot of trouble the last time they did it. I do not want to do it myself and have a conflict with them. We have a manteinance contract.
I would like to know if the BOM and SCAN is part of an extra module,
as our supplier says, or it is just that something is not properly installed, and we can push them to repare it.
Thak you very much in advance.
Juan

yes is necessary BOM_MANAGER License