points of reference projects

[andrea]

How I can set up of default in annotation the attributes of the points of reference projects to you?
I have inserted in the following rows am_customize lines :

(AM_MBP_SETTINGS
:circle_linetype :INVISIBLE
:lines_size 0.5
:lines_color :color 16776960 :done
:lines_linetype :DOTTED
:extension_color :color 16776960 :done
:extension_linetype :DOTTED)

but it does not work....

if instead I write to them on the command line goes....

Where mistake ??

[AndyHingston]

Hi Andrea,

The syntax that you are using is correct, as you already say that it works fine issued from the command line.

I have copy and pasted the same syntax into my am_customize file and I see your defaults.

Now one thing to try is to change the location of the entry in the am_customize file, as I have seen before that it can effect the setting of default options. Mine is the at the end, as follows:

(AM_MBP_SETTINGS
:circle_linetype :INVISIBLE
:lines_size 0.5
:lines_color :color 16776960 :done
:lines_linetype :DOTTED
:extension_color :color 16776960 :done
:extension_linetype :DOTTED)

(DISPLAY "CSI Annotation Customisation Loaded")

[andrea]

It does not work.........

[AndyHingston]

Hi Andrea,

Did you also insert the commands at the end of the file?

One other thing I thought of, is there any USER customisation loading, in particular, say an environment file?

Have you tried logging as a different user, if at all possible?

Or it may be worth renaming your user profile for modeling as follows and then starting OSD

C:\Documents and Settings\andy\Application Data\CoCreate\OSD_Modeling_ORIG

Of course you may already have tried these suggestions, but I cannot think of any other reason right now. But if you email me at andy.hingston@csi-europe.com I can send you my am_customize to try on your system.

[andrea]

Sorry not to have to you informed before. but I have resolved the problem...... I was modifying the rows mistaken....


Thanks...