rbrennen
06-01-2004, 02:25 PM
One of the great features of OneSpace Drafting (and its predecessor ME10) is the cleaning capability for 2D geometry. It finds overlapping geometry and then splits and deletes until there is only a single path of lines and curves. It also cleans up mismatched points (e.g. two lines that look like they end at the same point but are actually off by, say, .001 mm) so that one of the points is moved to match the other. This latter capability is not necessarily something I want but the cleaning up of overlapping geometry is something that would make a lot of sense when generating complicated geometries and models using a single workplane. I can't find any reference to this in the documentation. Is this capability available in OS Modeling?