rishimad
12-26-2003, 09:29 PM
Hello all!
Has anyone faced problems with gaps in a surface attached to a curved edge?
I have attached a bmp image(zipped) to show it better.
I have tried all the options-Reintersect,Grow,Insert,even skin (by splitting the edges),but it has not helped.
I have even tried refining the part and face accuracy,but that has not helped either.
Eagerly awaiting any suggestion!
Regards
Rishi
Has anyone faced problems with gaps in a surface attached to a curved edge?
I have attached a bmp image(zipped) to show it better.
I have tried all the options-Reintersect,Grow,Insert,even skin (by splitting the edges),but it has not helped.
I have even tried refining the part and face accuracy,but that has not helped either.
Eagerly awaiting any suggestion!
Regards
Rishi