PDA

View Full Version : Annotation: Sketch to view option if view was previously a sketch


Jfallert
09-09-2003, 02:41 PM
Thread should read: If view was previously a sketch... Have come across the problem recently... someone only has the 2d, so recreating the views isn't the easiest option.

The migrate a view (perhaps to be able to get rid of fold lines in a cable?) to a sketch and, even though no changes are made, there isn't an option to go back to a view? The most recent case was where a detail view was needed... and not possible because the needed view was migrated to a sketch.

A little unsure how AM differentiates between a view and sketch internally...

If 'copy view' was an option, this might be a moot point (or should I mention... the oft wanted but impossible with ME10 'undo' command?).

Jeff