May Kung
06-19-2003, 03:22 PM
Most users at my workplace are not aware of using the Put Dim In command (including myself until last week!). If we need to add a missing coordinate dimension, we just start a new group over, then delete the redundant zero points.
It would be nice if there was a way to highlight all the dims in a group. The Highlight Owner command can tell if all of the dims have the same View owner, but not if they are part of different groups. This would help when changing zero points on our prints for multiple groups.
It would be nice if there was a way to highlight all the dims in a group. The Highlight Owner command can tell if all of the dims have the same View owner, but not if they are part of different groups. This would help when changing zero points on our prints for multiple groups.