Steve
06-02-2003, 08:37 AM
I have a sketch that was created as the result of importing an ME10 .mi file. This sketch contains geometry, a hatch, and a couple of dimensions (it is a section of an O-ring).
I am trying to trim some lines in this sketch, and through I can click on them (it cycles through "click first, click second"), the geometry does not trim.
Any ideas what is causing this?
Thanks!
I am trying to trim some lines in this sketch, and through I can click on them (it cycles through "click first, click second"), the geometry does not trim.
Any ideas what is causing this?
Thanks!