jkramer
03-25-2003, 05:52 AM
One of our "new" OSD users was very surprised to find out that a part made in SheetAdvisor didn't have a density.
After all, the system "knows" that the part is made from steel, aluminium, whatever (sounds logic, doesn't it?).
So, my enhancement request for SheetAdvisor: an extra "density" variable in the toolshop (to be added to each material in the "materials" table) that, if set, would set the density of a new sheet part automatically.
Regards,
Jaap Kramer
After all, the system "knows" that the part is made from steel, aluminium, whatever (sounds logic, doesn't it?).
So, my enhancement request for SheetAdvisor: an extra "density" variable in the toolshop (to be added to each material in the "materials" table) that, if set, would set the density of a new sheet part automatically.
Regards,
Jaap Kramer