PDA

View Full Version : GD&T symbols in dimensions?


Steve
03-19-2003, 11:12 AM
Is it possible with Annotation to create GD&T symbols that are attached to dimensions, like Postfix text?

Steve

Steve
03-19-2003, 11:19 AM
How would one go about associating more than one line of text with a dimension?

The post, pre, sub, etc. texts allow you to enter a simple line of text, but what if I want more text associated with a dimension such that when the dimension moves the text goes with it?

Also, assuming this is not possible, how can I modify the dimension leader line on only one side of the dimension text (i.e. below the text) so that I can manually position a note there to make it "look" like it is part of the dimension text?

Steve