PDA

View Full Version : Get Bom from WM


gmatelich
12-27-2002, 09:41 AM
How do I tell Anno the get the BOM from WorkManager rather than from Modeling?

Mike Robbins
01-09-2003, 12:58 AM
Make sure you have generated the BOM in WM. They are not created just because you have saved the assemblies into the database. From inside of WM you Scan the assembly to create the WM BOM.

If you are using WM and not Model Manager,
from inside of Annotation you need to Open BOM (from your database menu). This reads the data from WM.

Then go about the business of drawing the BOM on your drawing and assigning the find numbers.

Hope this helps a bit.