Can it be unfolded?

[mlxjliao]

Hi,

can you help to check how to unfold attached part? I can create the unfold view in Annotation but can not unfold the 3d model.

thanks!

[jkramer]

Hi,

The problem is that OSD cannot unfold bends larger than 179 degrees or so. We found that out with a similar bend in Sheet Advisor. I attached a modified version of your model, where I put a small straight piece of 0.1 mm somewhere halfway the bend. Now it unfolds. A straight piece of 0.001 mm will probably work, too :)
I hope CoCreate will fix that limitation some day...
Kind Regards,
Jaap

[mlxjliao]

Jaap,

Thanks for your comment, it is very useful!

Best Regards
Johnson