kamazheng
09-16-2006, 09:12 PM
Who use the moldbase module?
I meet a problem of adding ejector pin at the position (0,0), the pin stay at a opposite direction, and I move it a little could be 0.01mm, the direction is right. why?
(I set the moldbase center at the world origin center).
I think the OSD is the best software for mold design, no parameter and the stronger anotation make it more quickly than other software, I used Pro/e, UG, SW before, no one could really have a entire solution for mold design ,especially for the 2D module, they are all too slow to stand.
there's some simple samples below:
http://bbs.icax.cn/attach/2006/09/14/2_uU4iDxkgvE2y.jpg
http://bbs.icax.cn/attach/2006/09/14/7_hMZpUCbP5aQr.jpg
http://bbs.icax.cn/attach/2006/09/14/5_ZX8uft7OHzOq.jpg
http://bbs.icax.cn/attach/2006/09/14/6_lpXfdYanlJ1V.jpg
I meet a problem of adding ejector pin at the position (0,0), the pin stay at a opposite direction, and I move it a little could be 0.01mm, the direction is right. why?
(I set the moldbase center at the world origin center).
I think the OSD is the best software for mold design, no parameter and the stronger anotation make it more quickly than other software, I used Pro/e, UG, SW before, no one could really have a entire solution for mold design ,especially for the 2D module, they are all too slow to stand.
there's some simple samples below:
http://bbs.icax.cn/attach/2006/09/14/2_uU4iDxkgvE2y.jpg
http://bbs.icax.cn/attach/2006/09/14/7_hMZpUCbP5aQr.jpg
http://bbs.icax.cn/attach/2006/09/14/5_ZX8uft7OHzOq.jpg
http://bbs.icax.cn/attach/2006/09/14/6_lpXfdYanlJ1V.jpg