drawing annotation print to me10

[andrea]

After to have created a design with cancelled ANNOTATION and having of the lines of geometry with it cancels calculated, when I go it to open with me10 me visualizes my design like in ANNOTATION but when I go R-in.stampa of press also the lines that I have cancelled the ANNOTATIO with cancels calculated. Excused for English bad ...


Dopo aver creato un disegno con ANNOTATION e avendo cancellato delle linee di geometria con il cancella calcolato, quando lo vado ad aprire con me10 mi visualizza il mio disegno come in ANNOTATION ma quando vado in stampa di stampa anche le linee che ho cancellato il ANNOTATIO con il cancella calcolato ..

[John Scheffel]

If I understand your question correctly, you are asking about deleted geometry which is still visible when you load the drawing into ME10.

The problem is that when you delete geometry in Annotation it is not really deleted, it is just hidden. It works this way so that you can "undelete" the geometry if you make a mistake. As we know all too well there is no Undo in Annotation, so this feature was added to provide limited undo for delete.

ME10 does not recognize the hidden flag on the geometry, so it displays and prints it. The solution is to use "Final cleanup" to truly delete the hidden geometry. To do this, click the Delete button and check All under Final Cleanup, say Yes to the warning, then click OK. Now save the drawing and load into ME10, the geometry should be gone.

[andrea]

The rows attached test to open it with Annotatio is an example. and then to open it with ME10 and stamparlo.. the visualization in ME10 it is various from the press. THANKS

[Gary Brauch]

Andrea,
If you do the cleanup as John recommended and then load it into version 11.65, the lines do not show up.
They will however print with the default setting in the print dialog.
In the print dialog, you must change the print content from "drawing" to "current show" and make sure you turn "spotlight" off.

Gary.