About Mold Design

[DesignerFans]

In the first step of Mold Design, It needs to set Pull Direction.
However, the Arrow size of Pull Direction is fixed.(isn't it?)

How to Resize the Arrow(red one) size of Pull Direction....
The Arrow seems to bigger especially the part is smaller....
Even It will cover the model to cause that cannot select the geometry on model.....

Any Way to make it better?
Thanks.

[dorothea]

Hi,

The arrow size is fixed. It doesn't depend on the size of the part. There is no way to change the size.
But you can switch the visibility off. Almost all commands use the set pull direction value as initial value for the pull direction specification in the other dialogs. So there is no need to specify the value again if you set it in initial step.

Dorothea